HP ProCurve 6120G/XG Configuration Manual page 242

Time Protocols
TimeP: Viewing, Selecting, and Configuring
Enabling Timep in Manual Mode. Like DHCP mode, configuring TimeP for
Manual mode enables TimeP. However, for manual operation, you must also
specify the IP address of the TimeP server. (The switch allows only one TimeP
server.) To enable the TimeP protocol:
Syntax: timesync timep
Syntax: ip timep manual < ip-addr > [oobm]
Syntax: no ip timep
N o t e
To change from one TimeP server to another, you must (1) use the no ip timep
command to disable TimeP mode, and then reconfigure TimeP in Manual
mode with the new server IP address.
For example, to select TimeP and configure it for manual operation using a
TimeP server address of 10.28.227.141 and the default poll interval (720
minutes, assuming the TimeP poll interval is already set to the default):
ProCurve(config)# timesync timep
ProCurve(config)# ip timep manual 10.28.227.141
9-34
Selects Timep.
Activates TimeP in Manual mode with a specified TimeP
server.
For switches that have a separate out-of-band management
port, specifies that TimeP traffic goes through that port.
oobm
(By default, TimeP traffic goes through the data ports.)
Disables TimeP.
Selects TimeP.
Activates TimeP in Manual mode.