Displaying A Debug/Syslog Configuration - HP ProCurve 6120G/XG Configuration Manual

C a u t i o n
If you configure a severity-level, system-module, logging destination, or
logging facility value and save the settings to the startup configuration (for
example, by entering the write memory command), the debug settings are
saved after a system reboot (power cycle or reboot) and re-activated on the
switch. As a result, after switch startup, one of the following situations may
occur:
■
■

Displaying a Debug/Syslog Configuration

Use the show debug command to display the currently configured settings for:
■
■
Syntax: show debug
ProCurve(config)# show debug
Figure C-5. Sample Output of show debug Command
Example: In the following example, no Syslog servers are configured on the
switch (default setting). When you configure a Syslog server, debug logging is
enabled to send Event Log messages to the server. To limit the Event Log
Only a partial set of Event Log messages may be sent to configured debug
destinations.
Messages may be sent to a previously configured Syslog server used in an
earlier debugging session.
Debug message types and Event Log message filters (severity level and
system module) sent to debug destinations
Debug destinations (Syslog servers or CLI session) and Syslog server
facility to be used
Displays the currently configured debug logging destinations
and message types selected for debugging purposes. (If no
Syslog server address is configured with the logging
addr command, no show debug command output is displayed.)
>
Debug Logging
Destination:
Logging --
10.28.38.164
Facility=kern
Severity=warning
System module=all-pass
Enabled debug types:
event
Troubleshooting
Debug/Syslog Operation
syslog-ip­
<
C-41