HP ProCurve 6120G/XG Configuration Manual page 221

second or third server, you must use the CLI. For more on SNTP operation
with multiple servers, refer to "SNTP Unicast Time Polling with Multiple SNTP
Servers" on page 9-37.
Syntax: timesync sntp
Syntax: sntp unicast
Syntax: sntp server <ip-addr> [version]
Syntax: sntp server priority <1 - 3 >
Syntax: [no] sntp server priority <1-3> <ip-address> [oobm] [version]
Syntax: no sntp server < ip-addr >
N o t e
Deleting an SNTP server when only one is configured disables SNTP unicast
operation.
For example, to select SNTP and configure it with unicast mode and an SNTP
server at 10.28.227.141 with the default server version (3) and default poll
interval (720 seconds):
Selects SNTP as the time synchronization method.
Configures the SNTP mode for Unicast operation.
Specifies the SNTP server. Server version values are between
1 and 7. The default server version is 3
Specifies the order in which the configured SNTP servers are
polled for getting the time. Value is between 1 and 3.
Use the no version of the command to disable SNTP.
specifies the order in which the configured SNTP serv­
priority
ers are polled for the time; allowable values are 1 through 3.
is an IPv4 or IPv6 address of an SNTP server.
ip-address
For switches that have a separate out-of-band management
port, specifies that SNTP traffic goes through that port.
oobm
(By default, SNTP traffic goes through the data ports.)
is the protocol version of the SNTP server. Allowable
version
values are 1 through 7; default is 3.
Deletes the specified SNTP server.
Time Protocols
SNTP: Viewing, Selecting, and Configuring
.
9-13