HP ProCurve 6120G/XG Configuration Manual page 579

Procurve series 6120 blade switches management and configuration guide
Hide thumbs Also See for ProCurve 6120G/XG:
Table of Contents

Advertisement

Lists the IP address or hostname of each hop in the route,
plus the time in microseconds for the traceroute packet reply
to the switch for each hop.
To halt an ongoing traceroute search, press the
Note: For information about traceroute6, see the "IPv6
Configuration Guide" for your switch.
<ip-address | hostname>
The IP address or hostname of the device to which to send the
traceroute.
[minttl < 1-255 >]
For the current instance of traceroute, changes the minimum
number of hops allowed for each probe packet sent along the
route. If minttl is greater than the actual number of hops, then
the output includes only the hops at and above the minttl
threshold. (The hops below the threshold are not listed.) If
minttl matches the actual number of hops, only that hop is
shown in the output. If minttl is less than the actual number
of hops, then all hops are listed. For any instance of
traceroute, if you want a minttl value other than the default,
you must specify that value. (Default: 1)
[maxttl < 1-255 >]
For the current instance of traceroute, changes the maximum
number of hops allowed for each probe packet sent along the
route. If the destination address is further from the switch
than maxttl allows, then traceroute lists the IP addresses for
all hops it detects up to the maxttl limit. For any instance of
traceroute, if you want a maxttl value other than the default,
you must specify that value. (Default: 30)
[timeout < 1-120 >]
For the current instance of traceroute, changes the timeout
period the switch waits for each probe of a hop in the route.
For any instance of traceroute, if you want a timeout value
other than the default, you must specify that value. (Default:
5 seconds)
[probes < 1-5 >]
For the current instance of traceroute, changes the number of
queries the switch sends for each hop in the route. For any
instance of traceroute, if you want a probes value other than
the default, you must specify that value. (Default: 3)
Troubleshooting
Diagnostic Tools
Ctrl
C
[
] [
]
keys
.
C-61

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 6120xgProcurve 6120 series

Table of Contents