Switch To Its Default Configuration; Transferring Startup-Config Files To Or From A Remote Server - HP ProCurve 6120G/XG Configuration Manual

With the same memory configuration as is shown in the bottom portion of
figure 6-22, executing erase startup-config boots the switch from primary flash,
resulting in a new file named minconfig in the same memory slot. The new file
contains the default configuration for the software version currently in pri­
mary flash.
Using the Clear + Reset Button Combination To Reset the

Switch to Its Default Configuration

The Clear + Reset button combination described in the Installation and
Getting Started Guide produces these results. That is, when you press the
Clear + Reset button combination, the switch:
• Overwrites the content of the startup-config file currently in memory
slot 1 with the default configuration for the software version in
primary flash, and renames this file to config1.
• Erases any other startup-config files currently in memory.
• Configures the new file in memory slot 1 as the default for both
primary and secondary flash locations (regardless of the software
version currently in secondary flash).
• Boots the switch from primary flash using the new startup-config file.
ProCurve# sho config files
Configuration files:
id | act pri sec | name
---+-------------+----------------------------------------­
1 | * * * | config
2 | |
3 | |
Figure 6-23. Example of Clear + Reset Result
Transferring Startup-Config Files To or From a Remote
Server
Command
copy config < src-file > tftp < ip-addr > < remote-file > < pc | unix > [oobm]
copy tftp config < dest-file > < ip-addr > < remote-file > < pc | unix > [oobm]
Switch Memory and Configuration
Multiple Configuration Files
Pressing Clear + Reset:
– Replaces all startup-config files with a single
file named config that contains the default
configuration for the software version in
primary flash.
– Resets the Active, Primary, and Secondary
assignments as shown here.
Page
below
below
6-37