Viewing Port Status And Configuring Port Parameters; Overview - HP ProCurve 6120G/XG Configuration Manual

Overview

This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■
■
■
■
■
■
Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Features
Feature
viewing port status
viewing transceiver status
configuring ports
configuring ProCurve auto-mdix
Note On Connecting
If the switch either fails to show a link between an installed transceiver and
Transceivers to
another device, or demonstrates errors or other unexpected behavior on the
Fixed-Configuration
link, check the port configuration on both devices for a speed and/or duplex
Devices
(mode) mismatch.
■
To display information about the transceivers installed on a switch, enter the
show tech receivers command in the CLI (page 10-14).
Enable/Disable
Mode (speed and duplex)
Flow Control
Broadcast Limit
Friendly Port Names
Uni-directional Link Detection (UDLD)
To check the mode setting for a port on the switch, use either the Port
Status screen in the menu interface (page 10-6) or show interfaces brief in
the CLI (page 10-8).
Default Menu
n/a page 10-6
n/a n/a
Refer to Table page 10-7
10-1 on pages
10-4 thru 10-5
Port Status and Configuration
Overview
CLI Web
page 10-8 page 10-22
page 10-14 page 10-22
page 10-15 page 10-22
page 9-11
10-3