Viewing Port Status And Configuring Port Parameters; Overview - HP ProCurve 2810 Series Management And Configuration Manual

Note On Connecting
Transceivers to
Fixed-Configuration
Devices

Overview

This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■ Enable/Disable
Mode (speed and duplex)
■
■ Flow Control
■ Broadcast Limit
Auto-MDIX
■
■ Jumbo Packets
■ QoS Pass-Through Mode
Configuring Port-Based Priority for Incoming Packets
■
Using Friendly (Optional) Port Names
■
Viewing Port Status and Configuring
Port Parameters
Port Status and Configuration Features
Feature
viewing port status
configuring ports
If the switch either fails to show a link between an installed transceiver and
another device, or demonstrates errors or other unexpected behavior on the
link, check the port configuration on both devices for a speed and/or duplex
(mode) mismatch. To check the mode setting for a port on the switch, use
either the Port Status screen in the menu interface (page 10-5) or show
interfaces brief in the CLI (page 10-7).
Default Menu
n/a page 10-5
See Table 10-1 page 10-6
on pages 10-4
and 10-4.
Port Status and Basic Configuration
CLI Web
page 10-7 page 10-15
page 10-10 page 10-15
Overview
10-3