OC-3 and OC-192 Interface Module LEDs
LED
Link status (L)
Speed (S)
OC-3 and OC-192 Interface Module LEDs
The table below summarizes the LEDs for the OC-3 and OC-192 interface module.
Table 46: Interface Module LEDs
LED
Power (PWR)
Status (STAT)
Carrier/Alarm (C/A)
Active/Loopback(A/L)
T1/E1 Interface Module LEDs
Table 47: 16-port T1/E1 Interface Module LEDs
LED
Active
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
180
Color/State
Description
Inactive or no connection
Off
Amber
Fault/loop condition
Green
Ok with activity or no activity
Off
Inactive port status
Green
Activity or no activity
Color/State
Description
Off
Disabled/no power to IM
Green
Enabled and power rails on IM in range
Disabled/power-down
Off
Red
Failure (on at reset)
Amber
Booting (if local CPU)
Green
Operational
Green
SFP receiving good remote signal
Yellow
Remote or local alarm activated
Green
SFP ready and operating normally
Yellow
SFP port in loopback state
Color/State
Description (two LEDs for eachT1/E1 port)
Green
Active
Blinking green
Standby
Off
Operationally down; card is disabled or shut down
Troubleshooting