Oc-192 Module Connections - Cisco XR 12000 Series Hardware Installation Manual

Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
Figure 2-29
OC-192/STM-64 POS/RPR XFP SPA.
Figure 2-29
The 40-pin connector on the 1-Port OC-192/STM-64 POS/RPR XFP SPA is used for resilient packet ring
Note
(RPR) connections. This feature is not supported in Cisco IOS XR Software Release 3.4.0.

OC-192 Module Connections

Table 2-32
SPA.
Table 2-32
Specification
Wavelength
Cabling distance (maximum)
Operating case temperature range
Tx Power
Receiver Sensitivity (maximum)
RX Overload
Maximum Receiver Power Damage
OL-17438-04
shows the cable type for use with the XFP optical transceiver module on the 1-Port
LC-Type Cable for the XFP Optical Transceiver Modules
RX TX
shows the OC-192 specifications for use with the 1-Port OC-192/STM-64 POS/RPR XFP
OC-192 Specifications
1-Port OC-192 STM-64 POS RPR XFP SPA Overview
/ /
/ / / /
Description
OC-192 SR-1: 1290 nm to 1330 nm
OC-192 IR-2: 1530 nm to 1565 nm
OC-192 LR-2: 1530 nm to 1565 nm
OC-192 SR-1: 2 km (1.2 miles)
OC-192 IR-2: 40 km (24.8 miles)
OC-192 LR-2: 50 miles (80 km)
OC-192 SR-1: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 IR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 LR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 SR-1: –6 dBm –1 dBm
OC-192 IR-2: –1 dBm +2 dBm
OC-192 LR-2: 0 to +4 dBm
OC-192 SR-1: –11 dBm
OC-192 IR-2: –14 dBm
OC-192 LR-2: –24 dBm
OC-192 SR-1: –1 dBm
OC-192 IR-2: +2 dBm
OC-192 LR-2: –7.0 dBm
OC-192 SR-1: +5 dBm
OC-192 IR-2: +5 dBm
OC-192 LR-2: +5 dBm
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
2-43