Table of Contents
Advertisement
EXTEGRA IP 9000 FX
5.10
Advanced Mode: Camera
5.11
Installer Menu
Click the Reboot button to restart the device. There is a ten (10) second pause before the
camera adjusts the lens focus. The entire reboot sequence lasts approximately 40 seconds.
Factory defaults
Click the Defaults button to restore the configuration settings defined in the camera's web
server to their default values. A confirmation screen appears. Allow 5 seconds for the camera
to optimize the picture after a mode reset.
5.12
Encoder Profile
For the video signal encoding, you can select a code algorithm and you can change the presets
for the profiles.
You can adapt the video data transmission to the operating environment (for example network
structure, bandwidth, data load). To this end, the camera simultaneously generates two data
streams (Dual Streaming), which compression settings you can select individually, for example
one setting for transmissions to the Internet and one for LAN connections.
Pre-programmed profiles are available, each giving priority to different perspectives.
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
Caution!
The profiles are rather complex. They include a large number of parameters that interact with
!
one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options.
Notice!
In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections. Keep this fact in mind when assigning the profile.
Notice!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
Profile name
If required, enter a new name for the profile.
Target bit rate
To optimize use of the bandwidth in the network, limit the data rate for the device. The target
data rate should be set according to the desired picture quality for typical scenes with no
excessive motion.
For complex images or frequent changes of image content due to frequent movements, this
limit can temporarily be exceeded up to the value entered in the Maximum bit rate field.
Bosch Security Systems
Operation Manual
Configuration via IP, Advanced Mode | en
17
2015.03 | 1.0 |
Advertisement
Table of Contents
