Preparing To Install Components; Selecting A Place To Work; Gathering The Tools You Need; Getting Help - Gateway 9210 User Manual

Preparing to install components

You must open your server case to install components. If you are not comfortable with
these procedures, get help from a computer service technician or contact Gateway
Technical Support.

Selecting a place to work

Work on your server in an area that:
■ Is clean (avoid dusty areas)
■ Is a low-static environment (avoid carpeted areas)
■
Has a stable surface on which to set your server
■ Has enough room to place all of your server parts
■ Is near a grounded outlet so you can test your server after installation
■ Is near a telephone (in case you need help from Gateway Technical Support). The
telephone must be directly connected to a telephone jack and cannot be connected
to your server.

Gathering the tools you need

Some tools and supplies that you may need to work on your server are:
■
A notebook to take notes
■
A Phillips screwdriver
■ A small flat-blade screwdriver
■ Small containers to store various types of screws
■ A grounding wrist strap (available at most electronic stores)

Getting Help

If you have questions about performing any of these procedures, contact Gateway
Technical Support. For more information, see
28
"Getting Help" on page
www.gateway.com
6.