Dialing With P-Keys - Pitney Bowes 9930 Operator's Manual

(Not in the U.K. version.) The Model 9930 is set at 3 redials at 3-minute intervals.
If you want to change the number of redials (0-15 attempts) or the interval
between redial attempts (1-10) refer to Section 5.7.1, Step #40. If no connection
is made after all redial attempts a Transmit Status report automatically prints.

4.4.4 Dialing with P-Keys

The five P-Keys (Numbers P1, P2, P3, P4 and P5) on the Model 9930 allow you
to store a frequently used AutoDial job. Once programmed, you can enter the job
by pressing the P-Key. P-Keys can be reprogrammed with new sets of jobs any
time and can perform other functions as well as sending to one or several
locations. See Section 5.5 for procedures to program a P-Key.
To dial with a previously programmed P-Key.
Do This
1. Insert the document face down in the Automatic
Document Feeder.
2. Press the appropriate P-Key, Example: Press P3.
3. If Multiple ID has been turned ON, scroll to desired
ID #01 to 24. Press YES. Otherwise Default ID will
be used. See Section 5.7.1 for programming
information.
This Happens
MODE/NORMAL
ORIGINAL/NORMAL
PK3: REGIONS
SELECT TRANSMIT ID
ENTER # OR
JOB#09 TO MEMORY
PAGE.1
TX STATUS REPORT
32
PRINTING NOW