Contrast (Original Key); Working With A Photo; Automatic Reduction - Pitney Bowes 9930 Operator's Manual

NORMAL: For documents with standard size characters.
FINE: For documents with relatively small characters or thin lines.
EXTRA FINE: For documents with detailed lines and characters. The receiving
party must possess Extra Fine capabilities (Pitney Bowes proprietary and/or
ITU-T standard) in order to benefit from this mode's feature. If not, the reception
will be accomplished in the Fine Mode. If it is necessary to receive in ITU-T
Extrafine, call the Pitney Bowes Diagnostic Center to have this feature turned
on. Installation of 2MB, 4MB or 8MB memory is necessary. The standard 1MB
Memory Card is not sufficient.
The selected transmission Mode also determines the speed at which the page is
sent. The finer the Mode, the longer it will take to transmit a page.

3.8.4 Contrast (ORIGINAL Key)

When transmitting dark documents, selecting DARK will allow the received copy
to be printed lighter than the original.
selecting LIGHT will allow the received copy to be printed darker than the original.
Place the document in the ADF face down then press the ORIGINAL Key. The
indicator corresponding to the selected level of contrast will illuminate.

3.8.5 Working with a Photo

The Model 9930 has a 64-shade gray scale scanning capability, providing high
quality halftone reproduction print quality. What is sent is what is received. You
can send or copy a document that contains a photograph (or halftone) by pressing
the PHOTOS Key on the Operator Panel. When the PHOTOS Key is selected,
the Mode indicator will automatically advance to FINE. To enhance image quality,
you may press the MODE Key if you desire higher or lower image resolution.

3.8.6 Automatic Reduction

The Model 9930 was shipped with a 250-sheet universal paper cassette
adjustable for letter, legal or A4 paper and the Print Auto Reduction ON. Each
page of a received document is first stored in memory. Based on the document
length the Model 9930 will then automatically calculate the suitable Reduction
Ratio to enable the entire document to print on a single page. It will reduce only
the amount necessary for everything to print. If you turn the Auto Reduction OFF
(see Section 5.7.1, Step #44) all documents will be received at their full size and
no reduction will occur.
When transmitting light documents,
24