Setting Send Restriction; Setting Reception Restriction - Kyocera TASKalfa 3051ci Operation Manual

Setup and Registration > Transmission Restriction

Setting Send Restriction

Restrict the other parties to which you send originals only to the ones registered in Permit FAX No. and Permit ID No. as
well as the ones registered in the Address Book. To change the sending restriction, follow the steps below.

Setting Reception Restriction

Restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No. and Permit ID No.
and senders registered in your Address Book. This mode also allows you to set a [Reject List] for Reception Restriction
so that reception from senders on the list of Rejected FAX numbers or from senders whose Local FAX Number is not
registered are rejected. To change the reception restriction, follow the steps below.
1
Press the [System Menu] key.
2
Press [FAX], [Next] of TX/RX Restriction, and then [Change] of TX Restriction.
3
To not use the sending restriction, press [Off]. To restrict the other parties to which you
send originals only to the ones registered in Permit FAX No. and Permit ID No. as well
as the ones registered in the Address Book, press [Permit List + Address Book].
4
Press [OK].
1
Press the [System Menu] key.
2
Press [FAX], [Next] of TX/RX Restriction, and then [Change] of RX Restriction.
3
To not use the reception restriction, press [Off]. To restrict the other parties from which
you receive originals only to the ones registered in Permit FAX No. and Permit ID No.
as well as the ones registered in the Address Book, press [Permit List + Address
Book]. To block incoming faxes from senders registered in Reject FAX No., press
[Reject List].
4
Press [OK].
6-34