Remote Switch Function; How To Register Remote Switch Dial; Using The Remote Switch Dial - Kyocera TASKalfa 3051ci Operation Manual

FAX Operation (Advanced) > Remote Switch Function

Remote Switch Function

You can start fax reception by operation from the connected telephone set. This function is convenient for using this
machine and a telephone set (commercially available product) in combination installed at places distant from each other.
To start fax reception by operation from the connected telephone set, use the following operation.
NOTE
In order to use remote switch, it is necessary to connect the tone signal-sending telephone set (commercially
available product) to the machine. However, even if it is a tone signal-sending telephone set, this function may not be
used satisfactorily depending on the type of telephone set. For details, contact our agent or the store where you
purchased this machine.

How to Register Remote Switch Dial

Remote switch dial is set to 55 at the factory, but you can change the dial number.

Using the Remote Switch Dial

To start fax reception by operation from the connected telephone set, use the following operation.
1
Press the [System Menu] key.
2
Press [FAX], [Next] of Reception, [Next] of FAX, and then [Change] of Remote SW
Dial.
3
Press [+]/[-] or the numeric keys to enter the number you newly register. (00 to 99)
4
Press [OK].
1
The connected telephone set makes a ringing tone.
2
Lift the handset of the telephone.
3
When you hear the fax tone from the handset, enter the two-digit remote switch dial
number using the dial button on the telephone set.
NOTE
The remote switch dial is set to 55 at the factory.
When entering the 2-digit remote switch dial number, press the numbers slowly. If
the numbers are pressed too quickly, the line may not switch to the machine.
4
The telephone line switches to the machine, and reception starts.
4-16