Kyocera TASKalfa 3051ci Operation Manual page 189

Fax system (w) operation guide rev-2.2013.1
Hide thumbs Also See for TASKalfa 3051ci:
Table of Contents

Advertisement

Internet Faxing (i-FAX) > What is i-FAX?
i-FAX Reception Flowchart
The procedure for receiving an i-FAX is shown below.
NOTE
When Direct SMTP is used, communication does not go through a mail server, and thus your machine directly
receives and prints a document sent from another fax machine.
Notes on Using i-FAX
To use i-FAX, you must connect this machine to a computer using a network cable and specify the network settings.
Refer to
i-FAX Settings on page 8-5
If you cannot successfully send an i-FAX to the recipient, you normally receive an E-mail error message from the
server. However, in some cases problems can arise such that you do not receive the error message. For important
faxes, you should contact the recipient to check whether the fax was successfully received.
Due to the low level of security in Internet communication, important documents should be faxed over a direct
telephone line.
Communication over the Internet may take some time due to network congestion or communication faults. Urgent
faxes should be sent over a direct telephone line.
Because Internet faxing sends the faxed originals as files attached to an E-mail message, you cannot communicate
directly with the recipient.
You cannot have a telephone conversation via the Internet.
The resolution, compression mode and paper sizes that you can use for transmissions are dependent on the
performance of the receiving machine. Check the specifications of the receiving machine before sending the fax. If
you do not know the specifications of the receiving machine, the recommended transmission settings are a resolution
of 200 × 200 dpi, the MH compression mode and a paper size of A4.
If only Direct SMTP, which does not go through a mail server, will be used, the SMTP settings / POP3 server settings
in the i-FAX settings are not necessary.
Functions not available when sending an i-FAX
The following functions are not available when sending an i-FAX. They are available when sending a normal fax.
Delayed transmission
Direct transmission
Polling transmission
Transmission using ECM communication
Another fax machine sends a fax to this machine's E-mail address.
The mail server receives the fax.
This machine downloads the fax from the mail server.
This machine prints the received fax.
for details.
Encrypted transmission
Sub address transmission
Send restriction by registering permitted FAX numbers
Send restriction by registering permitted ID numbers
8-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents