Configure Awms To Optimally Manage Dell Powerconnect Infrastructure (Global) - Dell PowerConnect W-Airwave Manual

Configure AWMS to Optimally Manage Dell PowerConnect
Infrastructure (Global)
AMP Setup General Page (Rate Limiting)
There are several SNMP tuning parameters which must be configured in order for AWMS to properly
monitor Dell PowerConnect infrastructure.
Figure 2 SNMP Rate Limiting
Navigate to AMP Setup > General page
Locate the Performance Tuning section
Enable SNMP Rate Limiting for Monitored Devices
Note : Enabling the SNMP Rate Limiting for Monitored Devices option above adds a small delay between each SNMP Get
request, thus the actual polling intervals will be longer than what is configured in Section 3. For example a 10 minute polling
interval will result in an actual 12 minute polling interval..
Click Save.
Device Setup Communication Page (Credential & Timing)
Credentials
AWMS requires several credentials to properly interface with Dell infrastructure. The Discover process
detailed in Section 3 requires proper global credential configuration.
Navigate to Device > Setup Communication page
Locate the Default Credentials section
Click on the Dell link