Print And Image Quality Problems - Fuji Xerox DocuPrint C5005 d User Manual

6.5

Print and Image Quality Problems

Symptom
Output is too light.
(Faded or unclear)
Color spots or color lines
appear on output.
Equally spaced smears appear
on output.
The paper is damp. Load fresh paper.
The paper is not appropriate for the printer. Load appropriate media.
Refer to
• " Supported Paper Type" (P. 111)
A drum cartridge or the fusing unit is damaged or has deteriorated. Depending on its
condition, the drum cartridge or fusing unit may need replacement. Contact our
Customer Support Center or your dealer.
Is the toner save feature enabled?
Select [Off] for [Toner Saver] in the [Image Options] tab on your print driver.
Refer to
• Online help for the print driver.
On the [Image Options] tab of your print driver, change the print density settings under
[Image Settings] or [Color Balance] and then try printing again.
Refer to
• Online help for the print driver.
Change the [Paper Type] setting and try printing again. For example, if [Paper Type] is
set to [Plain], try changing it to [Bond] or [Recycled]. If it is set to [Heavyweight], try
changing it to [Extra HW].
The paper path may not be clean. Print a couple of sheets or so to remove dirt from the
paper path.
A drum cartridge or the fusing unit is damaged or has deteriorated. Depending on its
condition, the drum cartridge or the fusing unit may need replacement. Contact our
Customer Support Center or your dealer.
The printer's interior (LED Printheads) may not be clean.
Clean the interior of the printer.
Refer to
• " Clearing the Interior (LED Printheads) of the Printer" (P. 255)
Cause/Remedy
6.5 Print and Image Quality Problems
251