A.8
Installing the Parallel Port Kit
This section describes how to install the Parallel Port Kit on the printer.
Parallel Port Kit (with frame)
Note
• The clamp that come with the option are not used with this printer.
Important
• Parallel Port Kit and Gigabit Ethernet Board Kit cannot be installed concurrently. If the Gigabit Ethernet
Board Kit is installed, remove the card by reference to "Removing the Gigabit Ethernet Board Kit"
(P. 425).
Installing the Parallel Port Kit
1.
Press the <
switch to turn off the power.
Note
• Make sure that there is no indication on the display,
and <Energy Saver> button is off.
2.
Open the front cover.
> side of the printer's power
Connector conversion cable
A.8 Installing the Parallel Port Kit
417