Tcp/Ip (Lpd) Note And Limitations - Fuji Xerox DocuPrint C5005 d User Manual

CSRF Protection for CenterWare Internet Services
• When the [CSRF Protection] setting is enabled on the CenterWare Internet Services,
access to CenterWarer Internet Service may be failed depending on the web browser in
use, the usage situation of the browser, or network environment. In such case, try to
access using any accessible computer.
Or, if you need to disable the [CSRF Protection], contact your system administrator.
If there is no accessible computer around your environment, contact our Customer
Support Center or your dealer.
"CSRF" is a method of attack that a malicious web site forces the user to perform some
operations on the other web site via the accessing computer. This feature prevents the
unintentional operations from being executed on CenterWare Internet Services and the
settings such as the printer settings from being changed once the user has accidentally
accessed to the malicious web site.

TCP/IP (lpd) Note and Limitations

The following notes and limitations apply to TCP/IP (lpd).
Printer Settings
• Take care to configure IP address settings correctly. IP addresses are maintained within
an entire system. Be sure to consult your network administrator before configuring IP
address settings.
• In some network environments, sub-network sub network mask and gateway address
settings also must be configured. Consult your network administrator about the settings
required for your printer.
• If memory is insufficient when a port is enabled, the port is automatically disabled. If this
happens, disable unused ports, change memory allocation, or install extension system
memory.
• Configure the size of the [LPD Spool] which represents the size of receivable buffer in
accordance with the printer's operating conditions. Receiving cannot be performed if the
size of the [LPD Spool] receivable buffer is smaller than the actual received data.
Configuring Computer's Settings
• Take care to configure IP address settings correctly. IP addresses are maintained within
an entire system. Be sure to consult your network administrator before configuring IP
address settings.
• Consult your NIS (Network Information Service) administrator whenever configuring
network settings (e.g., IP address) on a computer that is used under NIS (Network
Information Service).
Switching the Power Off
Note the following points whenever switching the printer's power off.
• When the [LPD Spool] setting is [Memory]
All of the print data spooled in the printer's hard disk, including data that is currently being
printed, is deleted. The print data does not exist is not available when the power is
switched back to on. However, print data may be saved on your computer if the power is
switched off immediately after requesting a print job. In this case, printing will be
performed from the saved print data when the power is switched back on again, even if
a new print job has been is requested.
434
A Appendix