Fuji Xerox DocuPrint C5005 d User Manual page 421

6. Pull the handle on the control board and
then carefully pull the control board out of
the printer. Place the control board on a
table top or some other flat surface.
Important
• When pulling out the control board, hold it with both
hands so you do not drop it.
7. Remove the two screws that secure the
Parallel Port Kit.
Note
• The screws you remove here may be used for
securing other optional kit on the control board
8. Remove the Parallel Port Kit from the
control board.
Parallel Port Kit removal is now complete.
If you need to install the Gigabit Ethernet Board Kit consecutively, proceed to step 8 in the
"A.9 Installing the Gigabit Ethernet Board Kit" (P. 422).
It no other installation for the optional kit is needed, install the dummy plate that you
removed in step 7 in the "Installing the Parallel Port Kit," insert the control board, and then
secure the board with three screws in place.
.
screw
A.8 Installing the Parallel Port Kit
421