Table of Contents
Advertisement
2.2
Switching On/Off the Power
Switching the Main Power On
By switching the main power on, the controller and memory are also turned on while the
<Main Power> lamp lights up on the control panel. Do not switch the main power off unless
you need to open the inside of the printer to install optional products and move or clean the
printer.
Important
• Do not switch off the main power immediately after switching on the main power. This may damage the
hard disk and the memory or cause a machine malfunction.
1.
Open the front cover.
2.
Press the < | > side of the printer's main
power switch to turn on the main power.
Note
• The <Main Power> lamp lights up on the control panel.
3.
Close the front cover.
Switching the Power On
Confirm that the main power is switched on before pressing the power switch.
The printer takes approximately 28 seconds to warm up and to be ready to print after
switching the power on. This may take more time depending on your machine configuration.
Switch the power off at the end of the day or when not using the printer for an extended
period of time.
1.
Press the < | > side of the printer's power
switch to turn on the power.
2.2 Switching On/Off the Power
57
Advertisement
Chapters
Table of Contents
