Network Connection - Fuji Xerox DocuPrint C5005 d User Manual

Network Connection

Use 1000BASE-T (When the optional Gigabit Ethernet Board Kit is installed) or a straight-
type network cable that supports 100BASE-TX and 10BASE-T.
Important
• It is necessary to use the category (CAT5) or enhanced category 5 (CAT5e) cable for connecting with
1000BASE-T. We recommend to use enhanced category 5 (CAT5e) cable or higher for its better signal
quality and counter-noise characteristic.
• 1000BASE-T may not be able to fully deliver its performance despite the Gigabit Ethernet Board Kit
installed, for it depends on the processing speed of the printer.
• Optional Parallel Port Kit and Gigabit Ethernet Board Kit cannot be installed at the same time.
1. Press the <
switch to turn off the power.
2. Open the front cover.
3. Press the <
power switch to turn off the main power.
Note
• The <Main Power> lamp goes out on the control
panel.
32
1 Printer Environment Settings
> side of the printer's power
> side of the printer's main