Staple Faults - Fuji Xerox Versant 3100 Press Optional Units Manual

4.
While holding the tabs on the new staple cartridge,
push in the cartridge until it seats.
Note Make sure that the
5.
Push the Saddle Stitch Unit "3" gently into the
machine until it stops.
6.
Close the cover.
7.3.2

Staple Faults

Follow the procedures on the following pages when printed sheets are not stapled or staples are bent.
Contact your local Fuji Xerox representative if the problem persists after you have tried the following solu-
tions.
If printed sheets are stapled as shown in the figures below, contact your local Fuji Xerox representative.
One side of staple rising up
Depending on the type of paper being stapled, the stapled nails may be bent. If the bent nails are stuck

inside the machine, they may eventually cause paper jams.
Important
When you open the cover of the staple cartridge, remove any bent staple. Otherwise it may cause staple

jams. Use the cover of the staple cartridge only when removing jammed staples.
marks are aligned.
Unstapled
Staple bent in reverse direction
Entire staple rising up
Bent staple
Flattened staple
Staple rising up with
center pressed in
Chapter 7 Finisher
69