Chapter 7: Ethernet Avb Endpoint Reception; Rx Splitter; Rx Legacy Traffic I/F - Xilinx LogiCORE IP Ethernet AVB Endpoint v2.4 User Manual

Table of Contents

Advertisement

Ethernet AVB Endpoint Reception

Rx Splitter

The input to the Rx splitter (see
interface of the connected Ethernet MAC. Received data from an AVB network can be of
three types:

Rx Legacy Traffic I/F

The signals forming the Rx Legacy Traffic I/F are defined in
synchronous to the Tri-Mode Ethernet MAC receiver clock, rx_clk, which must always
be qualified by the corresponding clock enable, rx_clk_en (see
This interface is intentionally identical to the client receiver interface of the supported Xilinx
Tri-Mode Ethernet MAC core (there is a one-to-one correspondence between signal names
of the block-level wrapper from the Tri-Mode Ethernet MAC example design, after the
legacy_ prefix is removed). This provides backward compatibility–all existing MAC
client-side designs which use the clock enable should be able to connect to the legacy
Ethernet port unmodified.
Operation of the Rx Legacy Traffic Interface is closely connected with the frame header
match results of the
obtain a match, the frame data does not appear on this interface
(legacy_rx_data_valid and legacy_rx_frame_good/legacy_rx_frame_bad
are not asserted). When a match is obtained these signals are asserted as described in the
following sections.
Ethernet AVB Endpoint User Guide
UG492 September 21, 2010
Precise Timing Protocol (PTP) Packets. Routed to the dedicated hardware
Packet Buffer"
which can be accessed by the
identified by searching for a specific MAC Destination Address.
AV Traffic. Routed to the
by searching for MAC packets containing a MAC VLAN field with one of two
possible configurable VLAN priority values (see
Legacy Traffic:. Routed to
which are not identified as PTP or AV Traffic will be considered legacy traffic.
"Legacy MAC Header Filters."
www.xilinx.com
Figure
5-1) is connected directly to the client Receive (Rx)
"Software Drivers."
"Rx AV Traffic
I/F"of the core. These packets are identified
"Rx Filtering Control
the"Rx Legacy Traffic I/F"
If the filters are enabled and do not
Chapter 7
"Rx PTP
PTP packets are
Register").
of the core. All packet types
Table
5-3. All signals are
Table
5-1).
65

Advertisement

Table of Contents
loading

Table of Contents