Avaya Communication Manager Administrator's Manual page 1303

Cama Outgoing Dial Guard (msec)
This field appears when
Valid entries
25 to 6375 in
increments of
25
Cama Wink Start Time (msec)
This field appears when
Valid entries
20 to 5100 in
increments of
20
Disconnect Signal Error (sec)
This field appears for ground-start trunk groups.
Valid entries
1 to 255 in
increments of 1
Flash Length (msec)
This timer is sent to TN436B, TN459B, TN464C (or later), TN465B (or later), (TN753 if Country is 23),
TN2146, TN2147, TN2184, and TN2199 circuit boards.
Valid entries
10 to 2550 in
increments of
10
Administrator's Guide for Avaya Communication Manager
November 2003
is cama (the trunk group type used for emergency 911 service).
Group Type
Usage
Enter the minimum interval between the seizure acknowledgment
on the receiving server or switch and the outpulsing of digits by this
server.
Group Type is cama.
Usage
Specifies the duration (the wait-for-wink-to-end time) for a
wink-start CAMA trunk. The wink must begin before the Outgoing
Seizure Response timer expires.
Usage
Enter the maximum interval that Communication Manager will wait
to receive a disconnect signal from the far-end after the local party
(a phone or tie trunk) goes on-hook. If the timer expires,
Communication Manager assumes a disconnect failure and takes
appropriate action, such as creating an error message.
Usage
Enter the duration of a flash signal generated toward the central
office.
Screen Reference
Trunk Group
1303