Avaya Communication Manager Administrator's Manual page 1269

Hide thumbs Also See for Communication Manager:
Table of Contents

Advertisement

Duplex
This field specifies whether a two-way trunk group allows simultaneous transmission in both directions.
This field appears when the
data, but only if the
NOTE:
Even if the trunk group supports full-duplex transmission, other equipment in a circuit
may not.
Valid entries
full
half
End-to-End Signaling
Auxiliary equipment such as paging equipment and music sources may be connected to Avaya
Communication Manager by auxiliary trunks. Communication Manager may send DTMF signals (touch
tones) to these devices. This field, which appears when the
equipment trunk groups), sets the duration of these tones.
Valid entries
60 to 360 ms in
increments of
10
NOTE:
For trunks that do not receive real answer supervision, a "connect" Event report is sent
when the Answer Supervision Timeout occurs.
Expected Digits
NOTE:
Set this field to blank if the Digit Treatment field is set to insert and the Digits field
contains a feature access code (for example, AAR or ARS) followed by digits. In this case,
the number of digits expected are set on the AAR and ARS Digit Analysis Table and AAR
and ARS Digit Conversion Table.
Valid entries
1 to 18
Administrator's Guide for Avaya Communication Manager
November 2003
Comm Type
field is avd or rbavd. It also appears if the
ISDN-PRI
field is enabled on the
Usage
Enter full in most cases: this allows simultaneous two-way
transmission, which is most efficient.
Enter half to support only one transmission direction at a time.
Usage
Use this field to set the duration in milliseconds of the touch-tone
signal that is sent to the connected equipment.
Usage
Enter the number of digits that the far-end media server or switch
sends for an incoming connection. If your end is absorbing digits on
this trunk group, the entry in this field must be larger than the entry
in the Digits field.
If you leave this field blank, you cannot administer digit absorption.
System-Parameters Customer-Options
field is cpe (customer-provided
Group Type
Screen Reference
Trunk Group
Comm Type
field is
screen.
1269

Advertisement

Table of Contents
loading

Table of Contents