Trunk Flash - Avaya Communication Manager Administrator's Manual

Screen Reference
Trunk Group
TN
Valid entries
1 to 100 (DEFINITY R,
S8700 IP-Connect)
Tip:
Double-check your entry. If you accidentally enter an unassigned tenant partition number,
the system will accept the entry but no calls will go to the trunk group.
Toll Restricted
Valid entries
y
n
Tip:
To find out what kind of line coding a trunk group member uses, check the
field on the DS1 Circuit Pack screen for the DS1 port to which the member is assigned.

Trunk Flash

Trunk Flash enables multifunction telephones on Avaya Communication Manager to access central
office customized services that are provided by servers at the far-end or Central Office (CO). These
central office customized services are electronic features, such as conference and transfer, that are
accessed by a sequence of flash signal and dial signals from the Communication Manager telephone on
an active trunk call.
Valid entries
y/n
Trunk Gain
This field specifies the amplification applied to the trunks in this group. With the values of the Trunk
Termination and Country fields, the value in this field also determines the input and trans-hybrid balance
impedance for TN465B, TN2146, TN2147, and TN2184 ports. All other CO and DID circuit packs are
set automatically to high
Valid entries
high
low
1284
Usage
Enter a Tenant Partition number to assign this trunk group to
the partition.
Usage
Enter y to prevent toll-restricted users from using a trunk access
code to make restricted outgoing calls over this trunk group.
Enter n if the field is automatic or if you don't want to restrict
access.
Usage
Enter y to allow trunk flash.
Usage
Enter high if users complain of low volume.
Enter low if users complain of squeal or feedback.
Administrator's Guide for Avaya Communication Manager
Line Coding
November 2003