General Controls: Lock - Korg Pa800 User Manual

218 Global edit mode

General Controls: Lock

SC Preset buttons
Touch these buttons to recall the corresponding presets. Each
preset contains a custom detuning of each note of the scale
(shown in the upper scale diagram). It also memorizes the
selected degree(s) of the scale (shown in the lower scale dia-
gram).
When no preset is selected, the default scale is automatically
recalled. This scale assigns a -50 cent value to all notes, and turns
all scale degrees off.
You can select an SC Preset, also by assigning the relevant func-
tion to the Assignable Switch or Assignable Footswitch.
To save the current scale programming to a preset, while in this
page choose the "Write Quarter Tone SC Preset" command from
the page menu, then select one of the preset locations where to
save the current settings (see "Write Quarter Tone SC Preset" on
page 231).
Upper scale diagram
Use this diagram to set the detuning of each note of the scale.
-99...0...+99 Note detuning in cents. Zero is no detuning, ±50
is a full quarter tone up or down, ±99 is nearly
one whole semitone up or down.
Lower scale diagram
Use this scale to turn detuning on or off. Applied detuning will
depend on the programming set with the Upper scale diagram,
or recalled by selecting one of the SC Presets.
When a note is detuned, a black dot appears in the correspond-
ing note of the diagram.
General Controls: Lock
This page, split in four panes that can be selected by means of
the corresponding side tabs, contains all the available locks,
sometimes grouped under just a single lock. Locks prevent
parameter values to be changed when loading data from a stor-
age device, or selecting a different Performance, Style or STS.
Locks
All the available locks. Lock them to prevent changes due to
loading or selecting different elements. These locks are also
found in various other pages, next to the locked parameter.
Hint: To save the status of the various parameters as a fixed status
for the Pa800, save all the parameters to Performance 1 of bank 1
(automatically selected when turning on the instrument), and save
these locks to the Global.
• Lock–Tuning pane
Master Transpose
When locked, master transpose is not automati-
cally changed when selecting a different Perfor-
mance or Style.
(See "Master transpose" on page 86).
Perf M.Transpose
When closed, this lock prevents a Performance
change to modify the Master Transpose. When
open, changing a Performance may also change
the Master Transpose.
(See "Master transpose" on page 86).
Hint: In order to avoid having the Master Trans-
pose setting change when selecting a different Style,
use the general Master Transpose Lock (the first
parameter in this page).
Note: When the Master Transpose Lock is closed,
this parameter has no effect. However, the Master
Transpose Lock also locks the Performance Trans-
pose.
Style Performance Master Transpose Lock
When closed, this lock prevents a Style change to
modify the Master Transpose. When open,
changing a Style may also change the Master
Transpose.
(See "Master transpose" on page 86).
Gbl