Standard Lane Controls - Korg wavestate native User Manual

Wave Sequencing 2.0
Sync Notes
Sounding Note
Timing Lane A1
Sample Lane A1
...
Step Seq Lane A1
Timing Lane
Sample Lane
...
Step Seq Lane
Mode = Single Multisample
(Multisample)
[List of Multisamples]
This selects the Multisample for the Step. Use the < and > arrows to step through Multisamples one by one, or click on
the name to bring up a browser window.
Start Offset
[Off, 1st...8th]
In addition to simply starting playback from the beginning, Multisamples may have up to 8 different pre-programmed
alternate starting points, or "Start Offsets. " These skip part of the beginning of the samples, either to make them more
gentle (for percussive sounds) or to make them start more quickly (for sounds with slow attacks). The number of
available offsets will vary depending on the specific Multisample.
If no alternate start points are available, this will show n/a.
Channel
[Stereo, Left, Right, n/a]
This applies to stereo Multisamples only; for mono Multisamples, "n/a" is shown. You can choose whether to use the
original Stereo signal, or only the Left or Right channels (in mono).

Standard Lane Controls

These controls apply to all lanes except Master. (Master still has Presets, however.) Some Lanes have special parameters
in addition to the standard controls, as described in the following sections.
Lane Preset
Lane Presets store all of the parameters for the Lane and its Steps. Explore the system by mixing and matching presets
for different Lanes.
A2 A3 A4 A5 A6
A2 A3 A4 A5 A1
A2 A3 A4 A2 A3
A7 A8 A9
A10 A11 A12
A2 A3 A4 A5 A1
A4 A2 A3 A4 A2
New Note
A7 A8 A9 A10 A11 A12
A2 A3 A4 A5 A1
A4 A2 A3 A4 A2
30
A2
A3
A2
A3