Standard Lane Controls - Korg modwave native Manual

Motion Sequencing 2.0
On: If at least one note of the Program is already playing, the Motion Sequence lanes for newly played notes will start
on the same steps as those of the oldest note. See the graphic below. There may still be variations due to per-note
modulation or Probability.
Sync Notes
Sounding Note
Timing Lane A1
Shape Lane A1
...
Seq Lane D A1
Timing Lane
Shape Lane
...
Seq Lane D

Standard Lane Controls

These controls apply to all lanes except Master. Some Lanes have special parameters in addition to the standard
controls, as described in the following sections.
Lane Preset
Lane Presets store all of the parameters for the Lane and its Steps. Explore the system by mixing and matching presets
for different Lanes.
Loop Start, Loop End
These control the Steps on which the Lane begins, ends, and loops. You can change them in real-time, while notes are
sounding—and also modulate them via LFOs, Envelopes, etc. The Loop Start must be less than or equal to the Loop
End.
These parameters control the Steps on which the Lane begins, ends, and loops. You can change them in real-time, while
notes are sounding—and also modulate them via LFOs, Envelopes, etc.
If you want to modulate loop points, use these parameters to set the maximum loop length. Loop Start can
only be modulated upwards, and Loop End can only be modulated downwards.
Repeats
[Off, 1...100, Inf]
This controls the number of times that the Lane will loop before resting on the last Step. The default is Inf, which causes
the loop to repeat as long as the note is held.
Loop Mode
This controls the direction of the loop: Forward, Backward, or alternating Forward-Backward.
A2 A3 A4 A5 A6
A2 A3 A4 A5 A1
A2 A3 A4 A2 A3
A7 A8 A9
A10 A11 A12
A2 A3 A4 A5 A1
A4 A2 A3 A4 A2
New Note
A7 A8 A9
A10 A11 A12
A2 A3 A4 A5 A1
A4 A2 A3 A4 A2
39
A2
A3
A2
A3