Points To Be Applied With Juki Grease B - JUKI AMS-210EN/IP-420 Instruction Manual

(3) Points to be applied with JUKI Grease B

Use grease tube B (part number: 40013640) (in light violet) supplied with the unit for add-
ing grease to any points other than the points specified below. If any grease other than the
specified one is used, the related components can be damaged.
■ Adding grease onto the eccentric cam section
2
■ Adding grease onto the oscillating rock shaft pin section
3
4
■ Grease supplement to the face plate section
4
1
2
6
7
8
1
2
4
2
1
4
6
5
3
5
1) Open crank rod cover 1 .
2) Remove setscrew 3 from the grease
inlet cover located at periphery of
6
crank rod 2 .
3) Fill coupling 4 with grease through
4
JUKI Grease B tube 5 .
4) Sink screw 6 supplied with the unit
3
into the coupling to add the grease.
5) After adding the grease, securely
tighten setscrew 3 which has been
removed.
5
1) Tilt the machine head and remove the grease
cover 1 .
2) Fill coupling 4 supplied with the unit with
grease through JUKI Grease B tube 5 .
3) Remove setscrew 3 in oscillator gear 2 and
screw in joint 4 into the screw hole.
4) Sink screw 6 supplied with the unit into the
coupling to add the JUKI Grease B.
5) Securely tighten setscrew 3 which has been
removed after replenishing with the grease.
1) Open the face plate cover.
2) Add the JUKI Grease B onto the felt sections
(3 locations), peripheral shoulder screw, ful-
crums 1 to 7 and guide groove section 8 .
– 125 –
The eccentric cam section
can be sufficiently filled with
grease by adding the grease
while turning the main shaft of
sewing machine.