Changing Sewing Mode - JUKI AMS-210EN/IP-420 Instruction Manual

B
G
D
E F

2-20. Changing sewing mode

3 Select the pattern No. of copy source.
Select the pattern button No. of copy source from the pattern
button list button B .
Next, press COPY DESTINATION INPUT button
the copy destination input screen is displayed.
C
4 Input the pattern No. of copy destination.
Input the pattern button No. of copy destination with ten keys D .
Pattern button No. which is not used yet can be retrieved with
– and + buttons
In addition, the folder to be stored can be selected with FOLD-
ER SELECTION button
5 Start copying.
When ENTER button
copied pattern button No. in the selection state returns to the
pattern button copy (copy source selection) screen after ap-
H proximately two seconds.
* Combination data can be copied in the same way.
1 Select the sewing mode.
When switch is pressed in the state that the pattern has
been registered, SEWING MODE SELECTION button
A
A is displayed on the screen. When this button is pressed, the
sewing mode changes alternately the individual sewing and
the combination sewing. (When the pattern button is not regis-
tered, the sewing mode cannot be changed to the combination
sewing even when the button is pressed.)
* The image of the button of sewing mode selection button
changes according to the sewing mode which is selected at
present.
When individual sewing is selected :
When combination sewing is selected :
– 63 –
( F and E ).
G .
H is pressed, copying starts. The
C and