Table of Contents
Advertisement
No.
Needle stop position is set.
UP position
Thread trimming can be prohibited.
Normal
Route of return to origin by return to origin button can be selected.
Linear return
Bobbin winding speed can be set.
Motion method of wiper can be selected.
Invalid
Unit of sewing shape size change can be selected.
%input
Thread tension output time when setting
thread tension can be set.
Bend position of thread clamp is selected.
0 : S type
1 : H type thin thread (#50 to #8)
2 : H type intermediate
3 : H type thick thread (#5 to #2)
Thread clamp and thread clamp position selection
Front position
Thread breakage detection selection
Thread breakage
detection invalid
Number of invalid stitches at the start
of sewing of thread breakage detection
Number of invalid stitches during sewing
of thread breakage detection
Item
Upper dead point
Thread trimming
prohibited
Reverse return of
Origin retrieval /
pattern
Sewing start point
Magnet typewiper
Actual size input
Rear position
Thread breakage
detection valid
– 98 –
Setting range
Edit unit
---
---
---
---
---
---
800 to 2000
100 sti/min
---
---
---
---
0 to 20
1
---
---
---
---
---
---
0 to 15
1 stitch
stitches
0 to 15
1 stitch
stitches
- Quick Links:
- Error Code List
Hide quick links:
Advertisement
Table of Contents
