JUKI AMS-210EN/IP-420 Instruction Manual page 19

[When using area 1306]
When area 1306 is used, connect the pneumatic components after having carried out [Connection
common to all areas].
Connector
Air tube
CN1
1A
CNS
CN2
!3
!1
!5
Air tube
1B
8
!3
CN3
Air tube 2B
Air tube 2A
!6
!4
6) Install air tubes coming from the machine head
and the cords coming from the control box to
the position as shown in the figure. At this time,
be careful of the number and alphabet of the
air tubes and the cords. (Adjust the alphabet
of the air tubes to the alphabet of the solenoid
valve. Also, adjust the figures to the figures of
the connector label.)
7) Connect air tube !3 of solenoid valve installing
plate A asm. !1 to solenoid valve asm. 8 .
8) Install the air tubes coming from the machine
head to the joint of solenoid valve installing
plate A asm. !1 as shown in the figure.
Install two stop plugs !6 supplied as accesso-
ries to !4 and !5 .
Install cords (CN2, CN3, CNS) coming from the
control box to the solenoid valve.
If a cable has a slack, fix the cable on
the table by means of a stapler sup-
plied with the unit.
At this time, provide the cable with an
adequate play (allowance) to prevent
the related connector from being ap-
plied with an excessive load.
– 15 –