Editing The Intermediate Presser Height - JUKI AMS-210EN/IP-420 Instruction Manual

A
B
A
I
C
H
F
K

(2) Editing the intermediate presser height

Press STEP SEWING button
display the step sewing screen.
The sewing shape is displayed at the center of the screen. The
current point, sewing start position and sewing end position
are respectively represented by (pink circle), (blue dot) and
(pink dot).
Press MODE SELECT button
ate presser mode.
When ONE-STITCH BACKWARD button
WARD button
moves backward or forward by one stitch. When two or more
commands have been entered, the feed position does not
B
change but the command display A is moved forward and
backward. When you keep pressing the button C or D , the
moving speed increases.
Indicated value B is the absolute value (Intermediate presser
height value + Intermediate presser height increased/de-
creased value).
When COMMAND SEARCH FORWARD button
BACKWARD button
ward or backward from the current point to reach the needle en-
try point where the first intermediate presser command is found.
To stop the feed, press button C , D , E , F , G or H .
When INTERMEDIATE PRESSER button
J
the intermediate presser is raised or lowered. (This button is
not displayed when MEMORY switch U103 is set at 0 (zero).)
When PRESSER INITIAL POSITION button
pressed, the work clamp moves to its origin and the screen is
restored to the sewing screen.
When COMMAND DELETE button
screen for deleting the command as shown in A is displayed.
D
When J is pressed, the intermediate presser height
G
increase/decrease input screen is displayed. Input a desired
value on this screen using numeric keypad and +/- keys K .
E
When ENTER button
1. When checking the needle, or performing the feed
forward or backward, the machine fails to work un-
less the presser is lowered. Use the machine after
lowering the presser.
2. When the intermediate presser rests at its lower position,
the movement of the intermediate presser and needle
differ depending on the setting of MEMORY switch U103.
3. When increasing the height of intermediate presser
or making the needle size thicker, confirm the clear-
ance between the wiper and the components. Wiper
cannot be used unless the clearance is secured. In
this case, turn OFF the wiper switch, or change the
L
set value of memory switch U105.
Refer to "@-3. MEMORY SWITCH DATA LIST" p.96
the memory switch settings.
– 44 –
A on the sewing screen to
B to select the intermedi-
D is pressed, the feed (current point )
F is pressed, the feed moves for-
I is pressed, the
L is pressed, the data is confirmed.
C or FOR-
E or
G is pressed,
H is
for