JUKI AMS-210EN/IP-420 Instruction Manual page 31

3) Folder structure of the media
Store each file in the directories below of the media.
Media drive
Data that are not stored in the directories above cannot be read. So, be careful.
4) CompactFlash (TM)
■ Inserting the CompactFlash (TM)
1. When the inserting direction is wrong, panel or media may be damaged.
2. Do not insert any item other than the CompactFlash (TM).
3. The media slot in the IP-420 accommodates to the CompactFlash (TM) of 2 GB or less.
4. The media slot in the IP-420 supports the FAT16 which is the format of the Compact-
Flash (TM). FAT32 is not supported.
5. Be sure to use the CompactFlash (TM) which is formatted with IP-420. For the formatting pro-
cedure of the CompactFlash (TM), see
VDATA
Store vector format data.
AMS
Store M3 data.
SDATA
Store sewing standard
data.
1)
2) After completion of setting of the media, close
・ Check that the media is securely pressed
Media
・ Check that the inserting direction of the
"@-2-28. Performing formatting of the media",
– 27 –
VD00 . VDT
VD00 . VDT
AMS0 . M3
AMS0 . M3
SD00 . DAT
SD00 . DAT
Turn the label side of the CompactFlash(TM)
to this side (place the notch of the edge to
the rear. ) and insert the part that has a small
hole into the panel.
the cover. By closing the cover, it is possible
to access. If the media and the cover come in
contact with each other and the cover is not
closed, check the following matters.
until it goes no further.
media is proper.
Vector format data :
Store in ¥VDATA.
M3 data :
Store in ¥AMS.
Sewing standard
format :
Store in ¥SDATA.
p.89.