Height And Angle Of The Work Clamp; Height Of The Work Clamp (S Type) - JUKI AMS-210EN/IP-420 Instruction Manual

1-3. Height and angle of the work clamp

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start or
the sewing machine.

(1) Height of the work clamp (S type)

1
6
1) Loosen screws 2 located on the right and left
A
2
2) After the adjustment of the height of the feed-
B
3
5
4
3) If the feed bracket is moved to its forward end
8
7
– 116 –
sides of feed bracket 1 . Moving cloth presser
stopper 3 to the direction B will increase the
height of feeding frame.
ing frame, securely tighten the screws 2 .
If plastic work clamp 4 is set on
feeding frame 5 with the work clamp
remained at the factory-adjusted height
at the time of delivery, needle tip 6
can interfere with plastic work clamp
4 . To prevent the interference, adjust
to decrease the work clamp height or
set plastic work clamp 4 with feeding
frame 5 held lowered by hand.
for adjusting the work clamp height etc., when
the power to the sewing machine is in the
OFF state, top end of wiper 7 interferes with
head of work clamp foot setscrew 8 . So, be
careful.
* As long as the power to the sewing machine
is in the ON state, no interference between
top end of wiper 7 and head of work clamp
foot setscrew 8 occurs when the feed brack-
et is moved within its X-Y movable range.