Replenishing The Designated Places With Grease - JUKI AMS-210EN/IP-420 Instruction Manual

1-12. Replenishing the designated places with grease

* Perform grease supplement when the errors below are displayed or once a year (either one
which is earlier).
If grease has decreased due to cleaning of the sewing machine or any other reasons, be sure
to immediately add grease.
D
When the sewing machine has been used for a certain number of
stitches, error "E220 Grease-up warning" is displayed. This display
informs the operator of the time of replenishing the designated
places with grease. Be sure to replenish the places with the grease
C
below. Then call the memory switch U245, press CLEAR button
A and set NUMBER OF STITCHES D to "0".
Even after the display of the error "E220 Grease-up warning", when
RESET key B is pressed, the error is released, and the sew-
B ing machine can be continuously used. Afterwards, however, error
code "E220 Grease-up warning" is displayed every time the power
is re-turning ON.
In addition, when the sewing machine is used further for a certain
period of time without replenishing the places with grease after the
display of error No. E220, error "E221 Grease-up error" is dis-
played and the sewing machine fails to operate since the error can-
not be released even when the RESET key is pressed.
C
When error "E221 Grease-up error" is displayed, be sure to replen-
ish the designated places below with grease. Then call the memory
switch U245, press CLEAR button
B
STITCHES D to "0".
When RESET key
designated places with grease, error code "E221 Grease-up warn-
ing" is displayed every time the power is re-turning ON afterwards
and the sewing machine fails to operate. So, be careful.
1. Error code E220 or E221 is displayed again unless
UMBER OF STITCHES D is changed to "0" after re-
A plenishing the designated places with grease. When
E221 is displayed, the sewing machine fails to oper-
ate. So, be careful.
C
2. When GREASE APPLYING POSITION DISPLAY but-
ton
applying position can be confirmed in the panel
display. Be sure, however, to perform the grease ap-
plying after turning OFF the power.
– 122 –
A and set NUMBER OF
B is pressed without replenishing the
C is pressed in each screen, the grease