Checking Pattern Shape - JUKI AMS-210EN/IP-420 Instruction Manual

2-7. Checking pattern shape

WARNING :
Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp.
A
B
A
C
H
F
1 Display the sewing screen.
Display the data input screen (blue) and press READY key
A . Then the back-light of LCD changes to green and
sewing is possible. When the work clamp is in its upper posi-
tion, the work clamp first comes down to its lower position and
then moves to the sewing start point.
Be careful not to get your fingers caught between the
work clamp and the throat plate.
2 Display the step sewing screen.
When STEP SEWING button
sewing screen is displayed.
3 Lower the presser with the foot switch.
The sewing machine does not start even when the foot
switch is depressed with this mode.
4 Proceed stitching with the presser lowered.
The sewing shape is displayed at the center of the screen. The
current point, sewing start position and sewing end position
are respectively represented by (pink circle), (blue dot) and
(pink dot).
Check the sewing shape using ONE-STITCH BACKWARD
button C and ONE-STITCH FORWARD button
D . When two or more commands have been entered, the feed
position does not change but the command display A is moved
forward and backward. When you keep pressing the ONE-
STITCH FORWARD or BACKWARD button, the moving speed
increases.
I
When the COMMAND SEARCH FORWARD button
is pressed, the feed automatically moves to the sewing end
position. When the COMMAND SEARCH BACKWARD button
F is pressed, the feed automatically moves to the sew-
ing start position.
To stop the feed, press button C , D , E , F , G or H .
D
When INTERMEDIATE PRESSER button
G
the intermediate presser is raised or lowered. (This button is
not displayed when MEMORY switch U103 is set at 0 (zero).)
E
5 Finish checking the shape.
When PRESSER INITIAL POSITION button
pressed, the work clamp moves to the sewing start position
and the screen is restored to the sewing screen. When CAN-
CEL button
sewing screen. When the work clamp does not rest at the sew-
ing start or end position, sewing can be started by depressing
the foot switch before sewing shape checking is not completed.
– 42 –
B is pressed, the step
I is pressed, the screen is also restored to the
E
G is pressed,
H is