Performing Modification Of Needle Entry Point; Editing The Thread Tension - JUKI AMS-210EN/IP-420 Instruction Manual

2-8. Performing modification of needle entry point

A
B
A
I
C
H
F
K

(1) Editing the thread tension

Press STEP SEWING button
display the step sewing screen.
When it is necessary to move the feed forward or back-
ward such as in the case of needle checking, the feed
does not move unless the work clamp is lowered. Be
sure to check the needle or other relevant operation
after having lowered the work clamp.
The sewing shape is displayed at the center of the screen. The
current point, sewing start position and sewing end position
are respectively represented by (pink circle), (blue dot) and
B
(pink dot).
Press the MODE SELECT button
tension mode.
When ONE-STITCH BACKWARD button
WARD button
moves backward or forward by one stitch. When two or more
commands have been entered, the feed position does not
change but the command display A is moved forward and
backward. When you keep pressing the button C or D , the
moving speed increases.
Indicated value B is the absolute value (Thread tension value
J
+ Thread tension command value).
When COMMAND SEARCH FORWARD button
or BACKWARD button
forward or backward from the current point to reach the needle
entry point where the first thread tension command is found.
To stop the feed, press button C , D , E , F , G or H .
D
When INTERMEDIATE PRESSER button
G
the intermediate presser is raised or lowered. (This button is
not displayed when MEMORY switch U103 is set at 0 (zero).)
E
When PRESSER INITIAL POSITION button
pressed, the work clamp moves to its origin and the screen is
restored to the sewing screen.
When COMMAND DELETE button
screen for deleting the command as shown in A is displayed.
When J is pressed, the thread tension value increase/
decrease input screen is displayed.
Input a desired value on the thread tension value increase/de-
crease input screen using numeric keypad and +/– keys K .
L
When ENTER button
firmed.
– 43 –
A on the sewing screen to
B to select the thread
D is pressed, the feed (current point )
F is pressed, the feed moves
I is pressed, the
L is pressed, the data is con-
C or FOR-
E
G is pressed,
H is