JUKI AMS-210EN/IP-420 Instruction Manual page 101

No.
Counter motion selection
Sewing counter
Height of eight of presser at the time
of 2 step stroke
Buzzer sound can be prohibited.
Without buzzer sound Panel operating sound Panel operating sound + error
Number of stitches
of thread clamp release is set.
Clamping timing
of thread clamp can be delayed.
Thread clamp control can be prohibited.
Normal
Feed motion timing is selected.
Set the timing in "–" direction when stitch is not
well-tightened.
State of the presser after end of sewing is selected.
Presser goes up
after moving at
start of sewing.
Presser lifting motion at the end of sewing can be set.
With presser up
Origin retrieval can be performed every time after end of
sewing (other than combination sewing)
Without origin retrieval With origin retrieval
Origin retrieval in combination sewing can be set.
Without origin
retrieval
State of presser when sewing machine stops by temporary
stop command can be selected.
Presser rise.
Item
No. of pcs. counter Bobbin counter
Prohibited
Presser goes up Presser goes up by pedal
immediately after operation after moving at
end of sewing.
Without presser up
Every time 1 Every time 1 cycle is
pattern is finished.
Presser rise with
presser switch.
– 97 –
Setting range
(Control by motor)
50 to 90
(Control by air)
10 to 300
1 to 7
－ 10 to 0
－ 8 to 16
start of sewing.
finished.
Edit unit
--- ---
1
--- ---
1
1
--- ---
1
--- ---
--- ---
--- ---
--- ---
--- ---