４．２．Adding, Removing, And Replacing Hard Disks; Addition Procedure - Fujitsu PRIMEQUEST 1000 Series User Manual

SVmco User Guide
# /sbin/service smartd start

When the system contains the SAS disk unit and is running with the
driver for SAS cards, which is provided as standard by Red Hat Enterprise
Linux 5 (Fusion MPT SAS Driver), hot replacement and hot removal are
not available.
This does not cause a problem for systems that contain the SAS array disk
unit.
The schedule for solving this problem is pending.
４．２．Adding, Removing, and Replacing
Hard Disks
This section describes procedures using the disk management command to add,
remove, and replace hard disks. These descriptions use a SASU internal hard
disk as an example. In the device names displayed by the disk management
command, iocx represents a SGPIO controller, and /dev/sdx represents a hard
disk.
４．２．１．Addition procedure
Add a hard disk by using the following procedure.
1. Insert the hard disk into an empty SASU slot.
137