Removal Procedure - Fujitsu PRIMEQUEST 1000 Series User Manual

SVmco User Guide
# /opt/fujitsu/SVmco/bin/diskctrl -l
ioc0
0 none
1 none Fault LED-Identify
Remarks
If the slot location is incorrect in step 4:
o
Turn off the blinking Fault LED by executing the location off function
of the disk management command.
# /opt/fujitsu/SVmco/bin/diskctrl -o ioc0/1
Repeat steps 3 and 4 by specifying other slots until the correct slot
location is confirmed.
４．２．２．Removal procedure
Remove the hard disk by using the following procedure.
1. To remove a hard disk containing a partition specified as a raw or swap
device, take action as follows.
If the hard disk contains a raw device:
o
If the hard disk to be removed contains a partition operating as a raw
device, terminate all the applications that may access this partition as
the raw device. Then, remove the hard disk.
139