Installation Flow; ６．１．２．Checks Before Svmco Installation - Fujitsu PRIMEQUEST 1000 Series User Manual

SVmco User Guide
６．１．１．Installation flow
For details on how to install SVmco, see
System and Bundled Software
For details on how to configure SVmco, see
Hat Enterprise Linux).
Remarks

After changing the MMB IP address on a partition or the management
LAN IP address,
restart SVmco. Otherwise, SVmco would not be able to report any
detected errors.

If you use SVIM to install the operating system, you need not manually
install SVmco. However, after installation with SVIM, you will need to
check and make settings according to
installation and
６．１．２．Checks before SVmco installation
This section describes the checks to make before SVmco installation.

Confirming PSA-to-MMB communication LAN settings

Confirming management LAN settings

Confirming the functions required for SVmco operation
Chapter 4 Installing the Operating
in PRIMEQUEST 1000 Series Installation
6.1.6 Settings after SVmco
2.1 Configuring SVmco (Linux: Red
6.1.2 Checks before SVmco
installation.
Manual.
205