Fujitsu PRIMEQUEST 1000 Series User Manual page 69

SVmco User Guide
3. Click the [Trap] tab.
4. Enter the specified community name in the [Community Name] field.
Then, click [Add to List].
5. Click [Add] in [Trap Send Destination].
Enter the host name or IP address of the server receiving the trap (i.e., the
trap destination). Then, click [Add].
Click the [OK] button.
6. Select [Action] - [Restart] from the menu bar to restart SNMP Service.

How to confirm a trap destination setting
To confirm a trap destination setting, use the standard SNMP Service trap sent
to restart SNMP Service in the above step 8. You can confirm the correct trap
setting by checking whether the trap was received.
Remarks
The operation performed in step 6 on the trap source machine restarts SNMP
Service.
After that operation, a Cold Start trap is posted to the trap receiving application
at the trap destination. Cold Start is a standard SNMP Service trap.
snmptrapd runs on the Linux machine that is the trap destination to receive traps.
snmptrapd outputs the following message to the system log. Confirm that the
Linux machine received the trap normally.
61