Configuring The Psa-To-Mmb Communication Lan - Fujitsu PRIMEQUEST 1000 Series User Manual

2.2.1 Configuring
communication LAN
This section describes how to confirm the settings for the PSA-to-MMB
communication LAN.
Communication between SVmco and the MMB requires that the partition have
an active NIC connected to the PSA-to-MMB communication LAN.
For the setting of the PSA-to-MMB communication LAN, use the following
procedure.
Note
In the following cases, you can not use event notification function of SVmco:

[Interface] of [MMB-PSA IP Address] in the [Network Configuration] -
[Network Interface] window of the MMB Web-UI is Disable

The following operation (execution of the configuration command of
PSA-to-MMB communication LAN) is not performed
1. Execute the PSA-to-MMB communication LAN setting command.
[SVmco installation folder]\opt\fujitsu\SVmco\sh\setpsalan.bat
Note
If the operating system has not been restarted after SVmco installation, the
PSA-to-MMB communication LAN setting command in step 1 will fail.
SVmco User Guidel
the PSA-to-MMB
42