Settings After Svmco Installation - Fujitsu PRIMEQUEST 1000 Series User Manual

SVmco User Guide
XXX depends on the version.
In the above example, the "any directory" is /tmp.
# cd /tmp
# tar xvzf SVmco-XXXRHEL5.tar.gz
4. Execute the following command.
# cd SVmco
# ./INSTALL.sh -SVIM
5. After the installation of SVmco, make the required settings. For details
on the setting method, see SVmco Setting Procedure for VMware and
Configuring SVmco (Linux: Red Hat Enterprise Linux

2.3.2 Settings after SVmco Installation

The settings after SVmco installation for VMware partly differ from those for
RHEL. This section describes only the different parts.
For details on the parts of the setting procedure that are the same as those for
RHEL, see the following.
Settings after SVmco Installation (VMware)
Settings after SVmco
installation
Configuring the PSA-to-
MMB communication
For VMware
2.3.3 Configuring the network
2.2
5).
67