Installation Flow - Fujitsu PRIMEQUEST 1000 Series User Manual

To operate the PRIMEQUEST 1000x2 series server, you need to first install
SVmco. Otherwise, the following restrictions apply.

Even under an REMCS agreement, no software errors are reported.

Hot maintenance of PCI cards is disabled. The partition must be
stopped for maintenance.
６．２．１．Installation flow
For the SVmco installation flow, see
and Bundled Software
details on how to configure SVmco, see
Server 2008).
Remarks

If you use SVIM to install the operating system, you need not install
SVmco. However, after installation with SVIM, you need to check and
make settings according to
6.2.6 Settings after SVmco

After installing SVmco, execute the SNMP security setting command
(setsnmpsec) before you perform the operation in the following situations.
For details on the command, see
(setsnmpsec).
You will be changing the SNMP Service security setting from
o
[Accept SNMP packets from any host] to [Accept SNMP packets from
these hosts].
You will be changing the MMB IP address.
o
Chapter 4 Installing the Operating System
in PRIMEQUEST 1000 Series Installation
2.2 Configuration SVmco (Windows
6.2.2 Checks before SVmco installation
installation.
3.5 SNMP Security Setting Command
SVmco User Guidel
Manual. For
and
216