Advertisement
Features and Functions
❏
64/128-bit WEP, WPA™, WPA2™
❏
Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for OPOS)
❏
OPOS, APD enabled
Part Names
The following view shows the part names of the UB-R04.
DIP Switches
When using this interface board, the interface of the TM printer must be selected as "parallel" with the appropriate
settings. Set the reset signal for pin 31 to "enable," if you are using a TM printer that has this setting. See the
manual for each TM printer for details.
How to Set Up the UB-R04
You can set the UB-R04 with the wireless LAN connection or USB connection by using one of the following
methods. For details, see the UB-R04 Technical Reference Guide.
Using a Web browser
Using the EpsonNetConfig Ver. 4.1 or later
Preparation
For wireless LAN connection
Printing a Status Sheet
Power on the printer. Wait for about 20 seconds. Then hold down the push button on the interface board for more
than 3 seconds. The printer prints the parameters for the UB-R04. You can check all setting values necessary (SSID,
Network mode, IP address, Subnet mask, Gateway address) for the network connection.
Factory Default Settings
The table below shows the UB-R04 default settings.
Parameters
Communication standard
Network mode
SSID
WPA certification
Encryption method
Passphrase
Connection
Set the setting of the host PC and AP to match the network setting that you have confirmed with the status sheet.
You can check whether the connection to the printer has been correctly done by inputting the ping command
through the command prompt.
Example: Ping 192.168.192.168
Note:
Although the example shows the address 192.168.192.168, use whatever IP address is reported on the status sheet.
Because the default IP addresses for all the wireless printers are the same, you should power on and configure only one printer
at a time.
For USB connection
Connect the USB cable and turn on the printer power.
Note:
Connect the USB cable only when setting. USB connection is available only for setting parameters.
Mini USB connector (for wireless LAN setting)
Settings
802.11b/g/n
Infrastructure mode
EpsonNet
WPA2-Personal
AES
EpsonNet
3
Wireless LAN
Supported
Supported
Push button
USB
Not supported
Supported
Advertisement
